| Expert Talk Free Expert Tips and Advices |
Home » Technology » GPS Timing For NTP Servers
GPS Timing For NTP ServersThe GPS system can be used to provide a highly accurate timing reference for computer network timing equipment such as NTP Server systems and other time critical applications.This article describes how the Global Positioning System can b The Global Positioning System is a US military solution for navigation. The system consists of 24 orbiting satellites. Each orbiting satellite has a highly accurate atomic clock synchronised to UTC time. The highly precise atomic clocks are used to calculate transmission times for coordination triangulation. However, the timing information provided by the satellites can also be used as an accurate timing reference for computer network timing systems, such as NTP Server systems. The GPS satellites are continuously broadcasting time and position information. This information can be obtained anywhere in the world with a simple GPS receiver and antenna. There are no set up or subscription fees to utilise the GPS system. Accuracy GPS receivers provide highly accurate position and timing information. Typically, a GPS receiver can provide positioning informa GPS Signals The GPS signals transmitted from each satellite are very weak low-power radio signals, designated band L1 and band L2. The L1 frequency is the civilian GPS signal transmitted at 1575.42 MHz. The signals travel by line of sight and can pass through clouds, glass and plastics but are blocked by objects such as metal and brickwork. Therefore, the ideal location for a GPS antenna is on rooftop with a full 360-degree view of the sky. Often, installation on the side of a building with a 180-degree view of the sky will provide adequate results, provided the horizon is not too obscured. As a rule of thumb, the better the view of the sky, the greater the likelihood of a good consistent signal lock. GPS Antenna Types The GPS antenna is effectively an amplifier that boosts the weak GPS signal for transmission along a cable to the GPS receiver. GPS antenna's provided with NTP server systems or static applications utilise a pole-mounting system. The antenna screws onto a threaded pole for installation on rooftops. This arrangement provides the antenna with a rigid mount easily able to withstand adverse weather conditions. Typically the GPS antenna is fairly small in size, measuring less than 90cm in diameter. Patch type antennas are also available that are particularly suited to mobile or vehicle applications. GPS Cabling Issues The cable distance that can be utilised by a GPS system depends mainly on the amplification of the antenna and the quality of coax used in the installation. Typically, a GPS antenna may provide a gain of between 20 to 40 db. Coax cable such as RG58 has an attenuation of 0.64 db/m at 1575 MHz. Therefore, a cable run of 40m can be utilised. Also allow for signal reduction through any connectors. GPS Amplifiers, Splitters and Surge Suppressors In-line GPS amplifiers provide further amplification of the GPS signal to increase the cable distance between the antenna and receiver. The amplifiers are fitted in-line on the coax antenna cable. A GPS amplifier may typically add a further 20 dB of gain, adding 30m of cable. Additionally, multiple in-line amplifiers may be utilised to further increase cable distance. GPS splitters allow a single GPS antenna to be utilised by two or more GPS systems. Multiple GPS sytems may reduce cabling costs by sharing a single antenna. The GPS splitter splits the signal received from the GPS antenna into multiple outputs for synchronizing multiple NTP servers. GPS splitters are generally available with 2, 4 or 8 outputs. Surge suppressors protect expensive NTP server equipment from electro-static discharges, such as lightning, that may be picked up by an externally mounted antenna. Surge suppressors are installed in-line on the coax cable between the antenna and receiver, ideally where the cable enters the building. Surge suppressors require a low-impedance ground, to discharge any surge picked up at the antenna. Article Directory: http://www.articledashboard.com D. Evans is a technical author with a wealth of experience, obtained over a 20 year period, in providing information on NTP server and computer timing equipment. Click here for more information and literature on computer network timing and NTP server systems. Permalink: http://expert-talk.com/tips/642/gps-timing-for-ntp-servers-17642.htm Related Tips and Advices
| Related Tags            |
SEND A COMMENT
PLEASE READ: All comments must be approved before appearing in the thread; time and space constraints prevent all comments from appearing. We will only approve comments that are directly related to the article, use appropriate language and are not attacking the comments of others.