| Expert Talk Free Expert Tips and Advices |
Home » Certification » Cisco CCNA Certification Training: Etherchannels And Spanning Tree Protocol (STP)
Cisco CCNA Certification Training: Etherchannels And Spanning Tree Protocol (STP)Cisco CCNA certification looks great on your resume, and it also teaches you vital real-world networking skills. One exam topic that you'll definitely see in today's networks is the configuration of an Etherchannel on a Cisco router. You need to knowIn this Cisco training tutorial, we'll use two switches that are connected at ports 0/11 and 0/12 via crossover cables. SW1 is the root bridge, SW2 is the non-root bridge. Even though there are two separate physical connections, spanning tree protocol (STP) will only allow the use of one, as verified by the partial output of "show spanning vlan 1" on SW2. Fa0/11 Root FWD 19 128.11 P2p Fa0/12 Altn BLK 19 128.12 P2p It's a waste of network resources not to use that second physical path. Additionally, there's going to be a delay in cutting over from 0/11 to 0/12 if the forwarding path goes down. We can get around both of these issues by creating an Etherchannel. An Etherchannel is a logical bundling of physical paths into one logical path. By configuring an Etherchannel on both 0/11 and 0/12, we will be left with one logical connection that will actually use the full capacity o SW1(config)#int fast 0/11 SW1(config-if)#channel-group 1 mode on Creating a port-channel interface Port-channel 1 The channel-group command must be configured on each physical interface that we want to place into the Etherchannel, so we'll have to configure it on ports 0/11 and 0/12 on both SW1 and SW2. Naturally, the group number used must match among all ports placed into the Etherchannel. Did you notice the router message "creating a port-channel interface port-channel 1"? You can verify the creation of that virtual interface just as you would a physical interface: SW1#show int port-channel 1 Port-channel1 is up, line protocol is up (connected) Hardware is EtherChannel, address is 000f.90e1.c24b (bia 000f.90e1.c24b) Note the readout "Hardware is EtherChannel". Also, where we once saw two physical ports when we ran "show spanning vlan 1", we now see only one - the port-channel. Also note that where the individual ports had a port cost of 19, the Etherchannel has a cost of 12 due to its increased bandwidth capabilities. Po1 Desg FWD 12 128.65 P2p Etherchannels give us a performance benefit and a fault tolerance benefit as well. Performance is increased since all physical channels between the two switches can be used, rather than the one STP allows by default. Fault tolerance is also increased, since a physical channel bundled into the Etherchannel can go down without an STP recalculation -- STP sees the Etherchannel as one single connection! Etherchannels aren't just important to know about for the CCNA exam, they're commonly used in real-world networks as well - so make sure you know how to configure and troubleshoot them! Article Directory: http://www.articledashboard.com Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage, home of over 200 free certification exam tutorials, including CCNA certification training articles. His exclusive CCNA study guide is also available! Visit his blog and sign up for Cisco Certification Central, a daily newsletter packed with CCNA, Network+, Security+, A+, and CCNP certification exam practice questions! A free 7-part course, ?How To Pass The CCNA?, is also available, and you can attend an in-person or online Cisco CCNA training boot camp with The Bryant Advantage! Permalink: http://expert-talk.com/tips/746/cisco-ccna-certification-training-etherchannels-and-spanning-tree-protocol-stp-21746.htm Related Tips and Advices
| Related Tags            |
SEND A COMMENT
PLEASE READ: All comments must be approved before appearing in the thread; time and space constraints prevent all comments from appearing. We will only approve comments that are directly related to the article, use appropriate language and are not attacking the comments of others.